Homemade Peanut Brittle Recipe (2024)

FAQs

Why didn't my homemade peanut brittle get hard? ›

The main reason why peanut brittle doesn't get hard and have the crunch we expect is because the sugar was not cooked long enough. The sugar needs to be cooked to what is called the hard crack stage, 300ºF.

Why did my peanut brittle turn out chewy? The likely cause is that the sugar mixture didn't reach the proper hard crack stage temperature. Ensuring it reaches 300˚F is key to getting that classic brittle texture.

Baking soda is also very important at this stage since it reacts to the heat, creating carbon dioxide that aerates the caramel, enabling it to snap when someone bites into it rather than requiring them to gnaw at it until it breaks or pulls apart.

Whether it's during the cooking, cooling, or storage process, moisture and humidity can ruin the best batch of brittle in minutes, leaving you with a soggy, sticky mess. This is why eliminating moisture anywhere you can is our top tip on how to store peanut brittle.

Just as in homemade syrup or caramel corn, baking soda causes a unique chemical reaction (basically a lot of rising foam) that is crucial in creating the right texture in peanut brittle. If you make it without baking soda but you will notice the brittle is a bit harder to bite through.

Quickly stir in butter and baking soda, then immediately pour mixture onto the prepared baking sheet. Quickly use 2 forks to lift and pull the mixture into a 12x14-inch rectangle. Let cool until completely firm, at least 30 minutes. Use a mallet to break peanut brittle into pieces.

So, I Googled Salvaging Undercooked Peanut Brittle and followed Tiffany's helpful instructions to throw the pieces back in the pan, turn the heat up and stir, stir, and stir to a raging boil and wait to pour it in the pan until it reaches 300 degrees.

Place a piece of parchment paper over the hot brittle and use a rolling pin to roll the peanut brittle into a 3/8-inch thick flat layer. Use a sharp chef's knife to partially cut the brittle while it is still warm. Allow it to cool completely before coating it with chocolate.

History. The combination is believed to have developed in the South during the 1920s, as a snack for blue-collar workers that did not require them to wash their hands. It quickly became popular as a summer snack, especially in rural areas. The snack became an internet trend in 2018.

Peanut brittle has one redeeming quality: peanuts. Outside of that single ingredient, peanut brittle is painfully unhealthy. It contains: sugar, corn syrup, and butter, all of which are unhealthy for your body in different ways.

How long is homemade peanut brittle good for? ›

This peanut brittle recipe will keep for up to 2 months if stored in an airtight container in a cool, dry place. I recommend placing pieces of wax paper or parchment paper between the candy pieces to keep them from sticking together.

If your peanut brittle is not hardening, it's because the sugar mixture did not get hot enough to properly caramelize, cool and become hard, crisp and crunchy. If you have this issue, next time, use a thermometer to make sure the peanut brittle mixture gets to 300°F.

To keep the brittle light and airy, do not spread or flatten the mixture.

Good news for all you peanut brittle lovers out there – yes, you can freeze peanut brittle! In fact, storing your brittle in the freezer can extend its shelf life for an extended period, ensuring that you have a delicious peanut treat to enjoy long after the holiday season has passed.

Put it in a pan on low heat and very slowly melt it. Once it begins to melt you can increase the heat a bit. The trick to this is that you have to stir it constantly in order to keep the peanuts from burning. You're going to want to bring it back to 300F, then immediately pour into the prepared pan.

Dried peanuts may require boiling up to 24 hours until they soften. If your water is hard, full of minerals, or you are boiling at high altitude, then your boiling times for dried peanuts may be greater than 24 hours.

Fudge Didn't Set

If your fudge turned out super sticky, or it didn't set as it cooled, it probably never got hot enough. This mistake is super easy to avoid if you use a candy thermometer and cook the fudge to the temperature specified in the recipe (usually between 234 and 239°F).